![]() There is little support from Makerbase so there needs to be a page adressing setup and use of the RUMBA+. The most notable being a port for use with touchscreens (TFT) controllers. There is also a new variant offered by Makerbase the RUMBA+. RUMBA is designed to be flexible in the user's power source availability, allowing any power supply from 12V-35V. The board features a developer friendly expansion port supporting giving access to all unused I/O, ADC and I2C pins. Its six motor outputs are powered by Pololu pin compatible stepper drivers. RUMBA is a feature rich all-in-one electronics solution for Reprap and other CNC devices. RUMBA (R.eprap U.niversal M.ega B.oard with A.llegro driver) 13.2 16U2 LUFA/Arduino based USB2Serial Firmware. ![]() ![]() 11.1 ATX power supply (controlled with RUMBA). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |